Tips on Tightening Your Plumbing Fittings

While working on your own plumbing at home, you must pay attention to your plumbing fittings. Taking the time now to quality check could save you several problems later on. The following information below will offer you several tips you can use when tightening the plumbing fittings in your home.

Right to tighten and left to loosen.

When you put in a screw, turning it to the left loosens the screw and turning it to the right tightens it. The same thing applies to plumbing fittings. If you remember which way you have to turn the fitting, you will avoid a bad seal or plumbing fittings that are potentially stripped. It is a common mistake that can easily be avoided.

Click here to find more tips on tightening your plumbing fittings read now to learn more.

Tight enough but not too tight.

For your plumbing to properly disperse water,  the pipes do not have to be secured super tight. The thought is that tighter is better because water will always find a way to get out of a pipe. When it comes to household plumbing, however, this simply is not the case. The way the plumbing fittings are made and put together, tightening the plumbing fittings may actually hinder your project instead of creating this tight seal. Many plumbing fittings have rubber seals inside them. If you tighten the fittings too tight, you can warp these seals. If that happens, you will have a higher probability of leaks.

Avoid stripping the threads.

The plumbing fittings are typically wide bolts. Inside each fitting are threads that screw onto the pipes to make a tight fitting. If you tighten the fittings too much, you run the risk of stripping these threads. Like any type of screw or bolt, if you strip a thread, you will find that it is harder to loosen the fitting as well as to turn it. This always creates potential for leaks to form or, in a worst-case scenario, a pipe to break under extreme circumstances such as cold or high pressure.

Use a plumber’s tape.

A handy tool of the plumber, plumber’s tape creates a stronger seal that is waterproof. The tape is typically made from silicone. Using this tape around your plumbing fittings while you tighten them will prevent you from tightening them too much. It will also protect against leaking where the fittings connects.

It is a must to always tighten your plumbing fittings to keep water from leaking out. If you have read the tips above but still can’t do it correctly then it is best to leave it to a professional.

 

Categories: Business

Comments are closed.